Use of DC freezer Suppliers' freezers

Comments · 201 Views

DC freezer Suppliers's Refrigerator usage advice

 

DC freezer Suppliers's Refrigerator usage advice

The following are some suggestions for the use of solar DC refrigerators to help you do a good job in the use of refrigerators.

The first point is that the refrigerated display cabinet is placed in a place away from heat sources, well-ventilated, firm and flat;
The second point: ensure that the distance between the cabinet and the surrounding is not less than 20cm, the back is not less than 10cm, and the top is not less than 50cm;

The third point is powered by a dedicated line. When the power supply voltage fluctuates greatly, a voltage stabilizer with more than 5 times the power of the whole machine should be installed;

The fourth point to note is that the transported freezer should be placed for more than two hours before power-on, and food can be added after two hours of power-on. The food in the cabinet should be at room temperature. When visiting items, pay attention to stacking them evenly to allow cold air to flow through the team;

Fifth, when using cold display cabinets, the number of opening doors should be minimized to prevent the loss of cold energy.

The sixth point, the refrigerated display cabinet should be managed by special personnel, and always pay attention to the operation of the equipment. If any abnormality is found, check it in time. If a major problem is found, a professional should be invited to repair it. When the 8mm thick frost layer accumulates, cut off the power, take out the object, rinse the surface frost layer with water to melt it all. Do not use a sharp metal defrost layer during this process to avoid damaging the evaporator. The last point is that the condenser should be cleaned every three months. Cut off the power first, then blow with compressed air. When the condenser surface is too oily, use a 1:20 sodium hydroxide solution on the condenser fins. After waiting for the accumulated oil to dissolve, rinse thoroughly with clean water. When cleaning wood with water, be careful not to get other electrical components wet.

 

For more product-related information, please click: Commercial Freezer

 

Comments