Solution To Burn Out Of Auto Ignition Coil Suppliers Winding Machine

Comments · 244 Views

Auto Ignition Coil Suppliers' automobile ignition coil winding machine burns out mainly because the insulation layer is aging and breakdown or the switching transistor is damaged.

  Auto Ignition Coil Suppliers' automobile ignition coil winding machine burns out mainly because the insulation layer is aging and breakdown or the switching transistor is damaged. The large gap of the spark plug causes the main coil to load and heat, and the insulation layer is aging quickly. The spark plug gap is small, resulting in high discharge current, secondary coil heating, and rapid aging of the insulation layer. The service life of the assembled ignition coil may be short, such as poor durability of the insulation material, large internal resistance and heat generation of the coil, and low quality of the triode.

   If the car ignition coil winding machine always burns out, it will burn out soon after replacement. What are the reasons? The following summarizes some:

   1. Let's look at the generator problem first. If the power generation is too high and the load is too heavy, the ignition coil is easily burned out. But if the power generation is too high, it will often damage the light bulbs and other body electrical appliances; of course, the quality of the accessories is not ruled out, so the power generation must be measured first.

   3. If the spark plug gap is too large, adjust the gap or replace the spark plug;

   4. The quality of gasoline is not good, try to change to high-quality gasoline;

   5. If the cylinder compression ratio is wrong, adjust the compression ratio;

   6. If there is a program failure on the computer board, you can go to the repair shop to check the car with the computer and clear the error message. If it doesn't work, there may be a problem with your car's transmission.

  7. The power supply voltage is unstable;

   8. If the resistance of the high-voltage line is abnormal, replace the high-voltage line;

  9. Secondary short circuit phenomenon;

  10. The primary current of the ignition controller is too high, which causes the ignition coil to overheat;

  11. There are problems under high temperature and high pressure waves, and the work is not good;

   12. The small chance is the coil itself, you can try other brands;

   13. Firearms integrated block is not easy to use;

  Distributor Ignition Coils Manufacturers' automobile ignition coil winding machine is itself a transformer, just like the transformer in household appliances. When the voltage changes within the specified range, the transformer will not be burnt out. Usually burning the transformer will only cause this situation when the transformer is overloaded. Therefore, when solving this problem, we should try our best to find out the cause of component overload or aging.

Comments