1. The external power supply gps car tracker magnetic must be connected to the car power supply before it can work 24 hours a day. Generally, it is impossible for criminals to use this product to track other people's vehicles. Because it must be connected to the power supply of the car, it is different from the general external locator. Therefore, it is not recommended to use an external power supply.

Second, the installation method:

1. If you know electricity, you can install it yourself. In fact, you only need to find the positive and negative poles of the car's power supply. The negative pole is very easy to find. The place where the car body is grounded is the negative pole. The positive pole is found in the fuse box. To the battery

2. It is best to connect to the normal power, which is the power cord directly drawn from the car battery that is not affected by the car key switch;

3. Note that the side of the gps car tracker magnetic with lights should face the sky, and the side facing the sky should not be close to the metal object to block the internal GPS antenna. It also needs to receive satellite signals from 20,000 kilometers away.

4. It can also be installed by relevant technical personnel, and the charge depends on the specific local conditions!

3. Installation location:

1. At the top of the car roof lamp above the front windshield;

2. The hidden place in the decorative panel under the front windshield;

3. A hidden place around the front dashboard;

4. In the door partition;

5.Under the decorative panel under the rear windshield;

6. Inside the front bumper, pay attention to waterproofing;

7. Under the wiper board, pay attention to waterproofing.

Note: If the windshield is pasted with a metal insulation layer or heating layer, it will reduce the GPS signal reception and cause the GPS to malfunction. At this time, pay attention to changing the installation location of the device.

gps car tracker magnetic https://www.eelinktracker.com/Magnetic-GPS-Tracker/